{"product_id":"servo-driver-module-shield-16-channel","title":"Servo Driver Module Shield 16 Channel","description":"\u003cp\u003e\u003cmeta charset=\"UTF-8\"\u003e\u003cspan\u003eservo motor driver You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that your microcontroller has a limited number of PWM outputs! Here is the Servo Driver Module Shield 16 Channel to help you out!!! What now? You could give up OR you could just get our handy PWM and \u003c\/span\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/servo-motors-and-accessories\/servo-controller\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eServo driver\u003c\/a\u003e\u003cspan\u003e shield. It’s now Arduino-ready and works with any \u003c\/span\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/arduino-2\/arduino\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eArduino\u003c\/a\u003e\u003cspan\u003e that uses shields: \u003c\/span\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/arduino-2\/arduino\/arduino-uno\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eUno\u003c\/a\u003e\u003cspan\u003e, \u003c\/span\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/arduino-2\/arduino\/arduino-mega\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eMega\u003c\/a\u003e\u003cspan\u003e, ADK, it's all good.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch5\u003e\u003cstrong\u003eUsing only two pins, control 16 free-running PWM outputs! You can even chain up 62 breakouts to control up to 992 PWM outputs\u003c\/strong\u003e\u003c\/h5\u003e\n\u003col\u003e\n\u003cli\u003eIt’s an I2C-controlled PWM driver with a built-in clock. That means that, unlike the TLC5940 family, you do not need to continuously send it the signal to tie up your microcontroller, it's completely free running!\u003c\/li\u003e\n\u003cli\u003eIt is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)\u003c\/li\u003e\n\u003cli\u003e6 address select pins so you can wire up to 62 of these on a single i2c bus, a total of 992 outputs – that’s a lot of servos or LEDs\u003c\/li\u003e\n\u003cli\u003eAdjustable frequency PWM up to about 1.6 KHz\u003c\/li\u003e\n\u003cli\u003e12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate\u003c\/li\u003e\n\u003cli\u003eConfigurable push-pull or an open-drain output\u003c\/li\u003e\n\u003cli\u003eThe output enable pin to quickly disable all the outputs\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003ch5\u003e\u003cstrong\u003eWe wrapped up this lovely chip into a breakout board with a couple of nice extras\u003c\/strong\u003e\u003c\/h5\u003e\n\u003col\u003e\n\u003cli\u003eTerminal block for power input (or you can use the 0.1″ breakouts on the side)\u003c\/li\u003e\n\u003cli\u003eReverse polarity protection on the terminal block input\u003c\/li\u003e\n\u003cli\u003eGreen power-good LED\u003c\/li\u003e\n\u003cli\u003e3 pin connectors in groups of 4 so you can plug in 16 servos at once (Servo plugs are slightly wider than 0.1″ so you can only stack 4 next to each other on 0.1″ header\u003c\/li\u003e\n\u003cli\u003e“Chain-able” design\u003c\/li\u003e\n\u003cli\u003eA spot to place a big capacitor on the V+ line (in case you need it)\u003c\/li\u003e\n\u003cli\u003e330-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial\u003c\/li\u003e\n\u003cli\u003eSolder jumpers for the 6 address select pins\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003cp\u003e\u003cspan\u003e\u003cem\u003e\u003cstrong\u003eWe have a wide range of Servo Motors and compatible Servo Cables available in our online store, click below to explore now\u003c\/strong\u003e\u003c\/em\u003e\u003c\/span\u003e\u003cspan\u003e \u003c\/span\u003e\u003cem\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/servo-motors-and-accessories\/servo\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eServo Motors\u003c\/a\u003e\u003c\/em\u003e\u003cspan\u003e \u003c\/span\u003e\u003cem\u003e\u003ca href=\"https:\/\/robu.in\/product-category\/servo-motors-and-accessories\/servo-extension-cable\/\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eServo Extension Cable\u003c\/a\u003e\u003c\/em\u003e\u003cspan\u003e\u003c\/span\u003e\u003c\/p\u003e\n\u003chr\u003e\n\u003ch4\u003e\u003cstrong\u003eFeatures :\u003c\/strong\u003e\u003c\/h4\u003e\n\u003col\u003e\n\u003cli\u003eThe I2C input, PWM output control 16 roads, steering gear can 16 roads.\u003c\/li\u003e\n\u003cli\u003eThe steering gear power independent V + input maximum 6 V.\u003c\/li\u003e\n\u003cli\u003eLogic signals and logical power independent output for 3V to 5 V.\u003c\/li\u003e\n\u003cli\u003e40-1000 Hz frequency.\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003chr\u003e\n\u003ch4\u003e\u003cstrong\u003ePackage Includes :\u003c\/strong\u003e\u003c\/h4\u003e\n\u003cp\u003e\u003cspan\u003e1 x Servo Driver Module Shield 16 Channel.\u003c\/span\u003e\u003c\/p\u003e","brand":"Jaideep Robotics","offers":[{"title":"Default Title","offer_id":46441551036589,"sku":"31371","price":547.0,"currency_code":"INR","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0773\/7638\/9293\/files\/image35.avif?v=1782634130","url":"https:\/\/jaideeprobotics.com\/products\/servo-driver-module-shield-16-channel","provider":"Jaideep Robotics ","version":"1.0","type":"link"}